The BeamZ COB50 is a high power 50W LED spot with a 60° beam angle featuring COB (chip-on-board) technology. It is RGBWA, with colour mixer, dimmer, strobe and DMX functions.
LCD Display
The COB50 control board offer several features. You can simply set the starting address, run the pre-programmed program or make a reset. You can then access the main menu by pressing the Mode button. Just browse through the submenu by pressing Up or Down. Press the Enter button in order to select the desired menu. You can change the selection by pressing Up or Down. Confirm every selection by pressing the Enter button. You can leave every mode by pressing the Mode button.
DMX-512 Connection
If you are using a standard DMX controller with the COB50, you can connect the DMX output of the controller directly to the DMX input of the first unit in a DMX chain. You should always connect the output of one unit; with the input of the next unit until all units are connected.
5-pin XLR DMX Connectors
Some manufacturers use 5-pin DMX-512 data cables for DATA transmission in place of 3-pin. Therefore, 5-pin DMX fixtures may be implemented in a 3-pin DMX line. When you insert standard 5-pin data cables into a 3-pin line; a cable adaptor must be used.
COB50 offers Master/Slave Operation
You can also use the master/slave operation which enables several of the same units. With the COB50 Multiple units can be controlled by one “master” unit. Connect the first unit “DMX OUT” socket with the second unit “DMX IN”, using a 3pin DMX Cable. Repeat this process with the third, fourth etc. Just choose the unit that will control all others and set this in master mode via the display. The other units that must react on the master, you must set in slave-mode. As a result, the “Slave” will synchronously follow the “Master”.
Warranty: 12 Months
Features
- 1x 50W COB LED
- Full-spectrum of light with COB technology
- DMX and Stand-alone mode
- 9 DMX channels
- Sound activated with adjustable sensitivity
- Auto mode with adjustable speed
- Pre-programmed shows
- DMX in/output via 3-pin XLR
- IEC-connector input/output
- Control panel with LED display
- The double bracket also acts as a floor stand
Specifications
Supplied features: Master/Slave mode
Light source: 5-in-1 LED
LED colours: Red, Green, Blue, Amber, White
LED power: 50W
Quantity of LEDs: 1
Beam angle: 60
DMX channels: 9
DMX connector: 3-pin XLR
Modes: Automatic programs, DMX
Power plug: IEC
Power consumption: 65W
Power supply: 100-240VAC 50/60Hz
Dimensions (L x W x H): 200 x 170 x 191mm
Weight: 1.10
Video
Watch a BeamZ COB50 demo at YouTube.